Wiring a sub box?
#1
What is the best way to run wiring into a sealed box?
Drill a hole and run the wire through it?
Drill 2 holes, split the wiring?
Buy an premade connector and mount it on the side?
My thinking is to split the wire and drill 2 smaller holes and then seal them with silicone. Less chance for air to escape with 2 tight fitting wires.
Am I way off here?
Drill a hole and run the wire through it?
Drill 2 holes, split the wiring?
Buy an premade connector and mount it on the side?
My thinking is to split the wire and drill 2 smaller holes and then seal them with silicone. Less chance for air to escape with 2 tight fitting wires.
Am I way off here?
#2
Guest
Posts: n/a
Any method works fine although I do the binding posts for boxes that may be coming out frequently.
My favorite is to put a couple of bolts through the box that have about six or seven threads outside the box and bolt the speaker wires down.
[ February 12, 2004, 09:01 PM: Message edited by: DWVW ]
My favorite is to put a couple of bolts through the box that have about six or seven threads outside the box and bolt the speaker wires down.
[ February 12, 2004, 09:01 PM: Message edited by: DWVW ]
#3
either method would work well GP, i wouldn't use the terminal box unless it was fabed into the box (aka premade) even then i'd probably take it out.
Drilling two holes sounds like a good idea to me though...less chance for air, although splitting wire isn't the most fun afternoon sport...lol...
are you going to use any sound deadening in the trunk?
Smooth.
Drilling two holes sounds like a good idea to me though...less chance for air, although splitting wire isn't the most fun afternoon sport...lol...
are you going to use any sound deadening in the trunk?
Smooth.
#5
Originally posted by DWVW:
Any method works fine although I do the binding posts for boxes that may be coming out frequently.
My favorite is to put a couple of bolts through the box that have about six or seven threads outside the box and bolt the speaker wires down.
Any method works fine although I do the binding posts for boxes that may be coming out frequently.
My favorite is to put a couple of bolts through the box that have about six or seven threads outside the box and bolt the speaker wires down.
I like anything that uses the KISS system. [img]graemlins/bow.gif[/img]
Thread
Thread Starter
Forum
Replies
Last Post
alexdbest2000
General Discussion
3
08-26-2007 10:37 PM
Kwalsh24
Install related
3
06-17-2004 02:30 PM