Iggy

I just bought a bunch of car audio and hooked it up this weekend.

HU- Alpine CDA 9886
Sub- Alpine 12" type R 4+4
Amp- Mono MRP 500

The head unit works and I have power going to my amp( blue light is on) I cannon get my sub to work though. I've tried everything I can think of. Power wire is good(since amp is working) Remote turn on is connected, Ground is good. I'm thinking it could be the rca's, I think they are in the right preouts, Their are 6 in the Headunit 3 White and 3 red for Front,Rear and SW. I put the red to the red sw and black to the white sw. For the amp I matched the red with the red and the black with the white. Speaker wire is connected fine and I wired it as shown here: _mono.jpg

What could be the problem. Could I have shitty rca's or something? Would this have anything to do with the remote/ground or is it just rcas/ speaker wire that could be the problem?

jalat

iTrader: (6)

is the subwoofer on via the headunit?

hold down the imprint button, which should be the furthest button on the right of the unit.

Killer_klown187

iTrader: (20)

it could be your rca's, have you tried going through your functions on your deck to see if you have a subwoofer volume control(usually seperate and sometimes defaults to OFF), Try turniong that function on.

Iggy

I didn't try the imprint button but I seen the sub woofer volume and maxed that out with no results. What options are in the imprint?

Killer_klown187

iTrader: (20)

Your manual will help best with this

jalat

iTrader: (6)

ps. just because the blue light is on doesnt mean there is power to the amp. sometimes the remote wire will trigger any lighting on the amp.

Iggy

Yeah its in my garage Ill have to wait until tomorrow to go look at it. Thanks,hopefully their is an option that I'm missing.

Iggy

I checked my connected like 1000 times so I doubt it could be that. Maybe a messed up a crimp that I can't see or something. Could it also be that the remote isn't working but the power wire is? Or just remote with no power?

jalat

iTrader: (6)

make sure no fuses are blown on the amp or the power wire. i take it the subwoofer is turned on because you have the ability to control the sub level.

jalat

iTrader: (6)

with my old hifonics amp, you could trigger all the lighting with just the remote wire, so you would think that the amp is ON, when in fact there was a small green light on the side telling you whetehr the amp was ON or not