CasinoGreek

I got a 2000 accord coupe and im looking for the best method of running wire from the mids in the door to the inside and then on back to the cross overs......

[ September 19, 2004, 09:22 PM: Message edited by: CasinoGreek ]

Bigmike216

maybe this thread might help?

http://www.canadiancaraudio.com/cgi/...;f=10;t=001386

Fever

iTrader: (1)

Great thread to post MikeMac; I had forgot about that one.

So are we pretty sure that 2000 Accord coupe has a molex on the door side? Undo it from inside the door?

slammed ex-r

200 Accord?? I dont think it has a molex plug????
I'm actually 99.9% sure it doesn't

CasinoGreek

well i looked at my door and from the outside it looks like the the first picture in the molex thread, i guess i wont find out for sure untill i open the door and take a good look....thanks for posting that thread though , ill know exactly what to do should i run into that problem.

maltesechicken

You won't know for sure until you actually get in there and start doing the work. My car doors looked like the first pic too, but I was lucky enough to find that it was just a wire housing with no plugs on either end (But a narrow one that was still tight to run 2 more wires through).

edgar

for those of you familiar with Honda molex's, is it possible to run two pairs of speaker wire through them? what is the largest gauge?

car is a '95 Integra btw, hoping to mount the x-over outside of the door

Fever

iTrader: (1)

^did you check out the link MikeMac provided?? It had pics of an Integra. I mean, what more do you need?
Two 16awg sure looks do-able.