rundown on install
#41
It will work, just no fader control. You will have to set your gains on your amps just right to get a good blend from rear fill. Also make sure you can turn off your "sub out" and pass full range or you will get nothing but low frequency. Too bad you cant turn in the deck and pay a little difference for something with front rear and sub out and prefereably not Sony...
#43
Nick
#44
i rewired my hole car today, moved the speaker amp from under the driver seat to the trunk, going to have both amps mounted to the sub box. i think the problem may have been how i wired the amp previously. I used the speaker outputs from the deck, doubled left and left and right with right, ran two speaker wires to the amp and into the high input. didnt use rca wires. i know, that was dumb and probly caused the problems. my deck only has one rear/sub rca output, will it work ok if i just put a Y cable into the deck and use a rca to each amp? can i just tape up the speaker wires from the deck and not use them? im so happy this hasnt cost me anything just time and effort (I love warranty), but hey what else am i doing with my summer... lol
Like the others said, y-adaptors will work, and turn the RCA output to full range. put but connectors on your unused wires, like the ones in the picture that I showed you yesturday.
Thread
Thread Starter
Forum
Replies
Last Post
metso
Install related
8
05-24-2007 03:49 PM