Problem I can't figure out...
#1
Problem I can't figure out...
I've got a JL W0 10 running off a MTX TN 250/1, a Sony CDX-GT270 source unit, and an Alpine MRP-F240 4 channel running the mids/highs.
There was an older MTX running the mids/highs but it kept overheating, I switched out the amp to the Alpine and now when I give it any volume the doors will sound clear until about half way up then just go to a bit of static and sound terrible, and since I hooked up the alpine the sub amp will not even come out of protection.
The power cable was a little corroded at the terminal so I took it off and cleaned it, ran through all the wiring that I could and found no imperfections, not sure if it may be the RCAs? I have no problem hooking everything up and doing basic troubleshooting but I think this may be beyond me. Any suggestions other than buying better equipment? (not my vehicle)
Thanks,
There was an older MTX running the mids/highs but it kept overheating, I switched out the amp to the Alpine and now when I give it any volume the doors will sound clear until about half way up then just go to a bit of static and sound terrible, and since I hooked up the alpine the sub amp will not even come out of protection.
The power cable was a little corroded at the terminal so I took it off and cleaned it, ran through all the wiring that I could and found no imperfections, not sure if it may be the RCAs? I have no problem hooking everything up and doing basic troubleshooting but I think this may be beyond me. Any suggestions other than buying better equipment? (not my vehicle)
Thanks,
Thread
Thread Starter
Forum
Replies
Last Post
ShockingCanada
Canadian General Car Audio Discussion
4
09-14-2008 08:40 PM