newbie question, bridging amp
#1
How do I bridge this?
On a 2 channel amp you bridge the + to the - correct? I am not sure about this tho because it isn't a 2 channel amp, it's a PPI mono bridged internally. Do I bridge it the same way as a 2 channel?? Just don't want to mess anything up.
On a 2 channel amp you bridge the + to the - correct? I am not sure about this tho because it isn't a 2 channel amp, it's a PPI mono bridged internally. Do I bridge it the same way as a 2 channel?? Just don't want to mess anything up.
#2
Usually mono amps cannot be externally bridged. They give you two speaker outputs to make "bridging" easier. So, if you want to use two subwoofers on this mono amp then give each one its own + and - and the brdging is done by the amp itself. If you try to stuff two subs into one + and -, it may damage the amp.
I cannot guarantee to be 100% right so check with a manual if you can find it.
[ June 03, 2005, 09:31 AM: Message edited by: JonathanAlexand ]
I cannot guarantee to be 100% right so check with a manual if you can find it.
[ June 03, 2005, 09:31 AM: Message edited by: JonathanAlexand ]
Thread
Thread Starter
Forum
Replies
Last Post