HELP: 2 amps installation!
#13
Originally posted by tihuana82:
I'm running 4 gauge power wires from battery to the distribution block. then two 8 guage wires, one going into amp 1( sony explode 500w max for 4 speakers), and the other going into amp2 (mtx blue thunder 280 max for sub). Then i ground the two amps separetly with 8 guage wires. If these info helps.
I'm running 4 gauge power wires from battery to the distribution block. then two 8 guage wires, one going into amp 1( sony explode 500w max for 4 speakers), and the other going into amp2 (mtx blue thunder 280 max for sub). Then i ground the two amps separetly with 8 guage wires. If these info helps.
#14
I usually go through the wheel well...sometimes you can even tie into the frame which is good but not necessary....make sure no paint or rust on surface......and maybe check to see if the RCA's are run on the opposite side of the car from the power wire
#15
Originally posted by tihuana82:
So does anyone know how to get rid of the buzzing??? someone suggested that it was the power wire being too close to the RCAs, but i did run RCAs on one side of the car and Power wires on the other. Thanx for any help!!!
So does anyone know how to get rid of the buzzing??? someone suggested that it was the power wire being too close to the RCAs, but i did run RCAs on one side of the car and Power wires on the other. Thanx for any help!!!
[ September 18, 2005, 10:49 AM: Message edited by: BigBubba ]
#16
Originally posted by Garvok:
I usually go through the wheel well...sometimes you can even tie into the frame which is good but not necessary....make sure no paint or rust on surface......and maybe check to see if the RCA's are run on the opposite side of the car from the power wire
I usually go through the wheel well...sometimes you can even tie into the frame which is good but not necessary....make sure no paint or rust on surface......and maybe check to see if the RCA's are run on the opposite side of the car from the power wire