DVC sub wiring question
#1
I'm looking at a used set of JLAudio 10w3d4 subs (dual 4 ohm coils) and I have a wiring question for you guys. Is it possible to only use one of the two coils? I need 2 four ohm loads with planned amp configuration. Will all the Thiele/Small parameters still be the same if only 1 coil in powered? Will it still have the same power rating? Will it still have good output?
Thanks in advance - this is the first time I will have worked with DVC subs so any help would be appreciated.
Also what would you guys consider a fair price to be on these? They're about 1.5 years old and looks like they are not v2 (the VC cover is convex).
Mark
Thanks in advance - this is the first time I will have worked with DVC subs so any help would be appreciated.
Also what would you guys consider a fair price to be on these? They're about 1.5 years old and looks like they are not v2 (the VC cover is convex).
Mark
#3
Thanks for the reply Haunz...I dug around on the JL site and found an FAQ that doesn't recommend it. I just remember a friend doing this once.
Anyone with an idea on a fair used price on these?
Mark
[ March 07, 2005, 08:10 AM: Message edited by: NOBASS ]
Anyone with an idea on a fair used price on these?
Mark
[ March 07, 2005, 08:10 AM: Message edited by: NOBASS ]
Thread
Thread Starter
Forum
Replies
Last Post
Jmon
Car Audio Technical Discussions
2
09-26-2012 01:16 AM
OPPressed
General Discussion
6
09-24-2007 02:49 PM
OrionMan
Car Audio Wanted (WTB)
0
04-16-2006 08:19 PM