trystin123

iTrader: (1)

hey i am gettin a 01 accent and by the looks of it the stock deck looks pretty decent.. im wondering if it has sub outputs on it or if i do change it do i even need a new din or will another single din deck fit in it??

trystin stoneman

jerdavey

The deck will be made by Clarion, and most of the accents I have worked on that have the clarion decks have RCA out, not necessarily sub out. To change the deck, you need to disconnect 3 heater cables that manually operate your vents and heater controls. If you manage to loosen the trim panel, then you will see the colour of the sheaths. Should be one yellow and two black. One black goes in behind the glove box, and the other black and yellow goes under the dash. Unclip and flip down the glove box, and you will see the cable attached to a white triangle of plastic. The other two can be reached by lying on your back on the drivers side and looking up behind the radio. The factory radio has 2 brackets on either side that can be removed from the unit and used with most aftermarket.

Hope that helps

trystin123

iTrader: (1)

thanks yea that helps allot

AeR0

iTrader: (9)

hey there, i am trying to help trystin123 get at the rear of this deck. not having much luck. so i came on here and saw your help so basically here are the steps i need to take to getting the trim panel off correct?


1.loosen the one yellow and two black are they cables or what??
2.is there any screws that need to be loosened?

MR2NR

iTrader: (66)

Follow the ends of the cables to where they connect to the actual vent end hidden behind the dashboard. Not the ends where they connect to the control buttons. It is the other end that must be disconnected off of the vents themselves. Once they are disconnected, 2 on the lower drivers side, one on passenger side behind glovebox, then the entire center console can be moved and the cables come along with it.

AeR0

iTrader: (9)

how do they remove?

so basically i have to reach up in behind the hvac controls and remove them there correct?

only 3 cables hold this trim panel on?

rahim

no one mentioned the screws in the cup holders? one on each side, open them half way to get access

AeR0

iTrader: (9)

i saw those screws thanks

AeR0

iTrader: (9)

so how do these cables disconnect?