My proposed setup -- comments? concerns?
#1
As mentioned before, I am a total newbie to car audio. I just want to improve the quality of car audio, not compete in SQ competitions. I am told that the stock seven-speaker system in my 2002 Nissan Sentra GXE is quite good (four speakers, two tweeters, crappy sub). I am going for an all-Clarion setup since my stock speakers are already made by Clarion.
DXZ835MP ProAudio head unit
APX401.4 amp to power my speakers
APX401.2 amp to power my sub
XW1000 ProAudio 10" sub
I know a friend who will be building me a box for my subwoofer and installing everything.
Here is the dilemma ... I have another friend who gets me amazing deals on the Clarion hardware. The catch is that the stuff I get is non-refundable. If it's defective, yes, I can get it exchanged, but if I screw up and ask for non-compatible components, then I'm stuck with them.
So ... my questions? Is this equipment "compatible" with each other? Do I need anything else besides the dash kit for the deck and the appropriate wiring?
Thanks
DXZ835MP ProAudio head unit
APX401.4 amp to power my speakers
APX401.2 amp to power my sub
XW1000 ProAudio 10" sub
I know a friend who will be building me a box for my subwoofer and installing everything.
Here is the dilemma ... I have another friend who gets me amazing deals on the Clarion hardware. The catch is that the stuff I get is non-refundable. If it's defective, yes, I can get it exchanged, but if I screw up and ask for non-compatible components, then I'm stuck with them.
So ... my questions? Is this equipment "compatible" with each other? Do I need anything else besides the dash kit for the deck and the appropriate wiring?
Thanks
#2
Here are the specs on the amps and sub
APX401.4
4/3/2 CHANNEL POWER AMPLIFIER
• NEW Heat Sink Design
• Maximum Power Output 400W
• Continuous Average Power Output 200W (50W x
4 into 4 Ohms 20Hz-20kHz @0.05% THD)
• Typical 2-Ohm Stereo 90W x 4 @ 0.5% THD
• Typical Bridged Power 1kHz 190W X 2 @ 0.5% THD
• Bass Extender Control 0~18dB @ 45Hz
• Adjustable 55Hz - 5.5kHz, 12dB/oct. High/Low Pass Crossover
• Mixed-Mode Operation
• Bridgeable 2/1 Channel Operation
• Speaker Level Inputs
• Double-Sided Glass Epoxy Circuit Board
APX401.2
2/1 CHANNEL POWER AMPLIFIER
• NEW Heat Sink Design
• Maximum Power Output 400W
• Continuous Average Power Output 200W (100W x 2 into 4 Ohms 20Hz-20kHz @0.05% THD)
• Typical 2-Ohm Stereo 190W x 2 @ 0.5% THD
• Typical Bridged Power 1kHz 380W @ 0.5% THD
• Bass Extender Control 0~18dB @ 45Hz
• Adjustable 55Hz - 5.5kHz, 12dB/oct. High/Low Pass Crossover
• Mixed-Mode Operation
• Bridgeable 2/1 Channel Operation
• Speaker Level Inputs
• Double-Sided Glass Epoxy Circuit Board
XW1000
· Polypropylene Woofer Cone with A Special Aluminum Coating
· S.E.T. Spider Exhaust Technology
· Dual 4 Ohm Voice Coil
· Cast Aluminum Basket with Unique Design
· Heat Resistant TIF Voice Coil
· Rear-Vented Pole Piece
· Inverted Rubber Surround
· Polypropylene Dust Cap with Clarion Embossed Logo
· Chrome-Plated Connectors
· Large Double-Stacked Strontium Ferrite Magnet
· 800 Watt Maximum Music Power
APX401.4
4/3/2 CHANNEL POWER AMPLIFIER
• NEW Heat Sink Design
• Maximum Power Output 400W
• Continuous Average Power Output 200W (50W x
4 into 4 Ohms 20Hz-20kHz @0.05% THD)
• Typical 2-Ohm Stereo 90W x 4 @ 0.5% THD
• Typical Bridged Power 1kHz 190W X 2 @ 0.5% THD
• Bass Extender Control 0~18dB @ 45Hz
• Adjustable 55Hz - 5.5kHz, 12dB/oct. High/Low Pass Crossover
• Mixed-Mode Operation
• Bridgeable 2/1 Channel Operation
• Speaker Level Inputs
• Double-Sided Glass Epoxy Circuit Board
APX401.2
2/1 CHANNEL POWER AMPLIFIER
• NEW Heat Sink Design
• Maximum Power Output 400W
• Continuous Average Power Output 200W (100W x 2 into 4 Ohms 20Hz-20kHz @0.05% THD)
• Typical 2-Ohm Stereo 190W x 2 @ 0.5% THD
• Typical Bridged Power 1kHz 380W @ 0.5% THD
• Bass Extender Control 0~18dB @ 45Hz
• Adjustable 55Hz - 5.5kHz, 12dB/oct. High/Low Pass Crossover
• Mixed-Mode Operation
• Bridgeable 2/1 Channel Operation
• Speaker Level Inputs
• Double-Sided Glass Epoxy Circuit Board
XW1000
· Polypropylene Woofer Cone with A Special Aluminum Coating
· S.E.T. Spider Exhaust Technology
· Dual 4 Ohm Voice Coil
· Cast Aluminum Basket with Unique Design
· Heat Resistant TIF Voice Coil
· Rear-Vented Pole Piece
· Inverted Rubber Surround
· Polypropylene Dust Cap with Clarion Embossed Logo
· Chrome-Plated Connectors
· Large Double-Stacked Strontium Ferrite Magnet
· 800 Watt Maximum Music Power
#4
Everything looks fine man, my friend has the 835 and I personally think its an awesome deck for the price.
1 question is if the 401.2 does 380 x 1 @2ohm which im guessing it does. If thats true then everything looks to be in order.
1 question is if the 401.2 does 380 x 1 @2ohm which im guessing it does. If thats true then everything looks to be in order.
#5
Originally posted by scarlemthug:
1 question is if the 401.2 does 380 x 1 @2ohm which im guessing it does. If thats true then everything looks to be in order.
1 question is if the 401.2 does 380 x 1 @2ohm which im guessing it does. If thats true then everything looks to be in order.
The answer is YES ... I emailed Clarion and they reassured me that the APX401.2 does the two ohm mono load that I need :-D
Thread
Thread Starter
Forum
Replies
Last Post
Contradiction
General Discussion
2
05-10-2011 02:02 AM
Hardcore Rock Superstar
Off-topic Chat
8
05-03-2006 06:36 PM