Audio_Rookie

iTrader: (2)

High guys, recently got a tdx 10d2 and it had a small dent on the cone when i got it, and then my mother dropped a camera on it and it has a bigger dent near center of cone...it dosnt look as nice.

Any way to remove those dents aside from a recone?

Thnx guys.

MR2NR

iTrader: (66)

Vaccuum cleaner, pinhole and pull it out like a dentpuller would with a small paperclip with a 90 degree bend in it. I imagine that this is the dustcap you are talking about and not the cone. A small amount of compressed air blown in the backside of it may pop it out as well.

Tim Baillie.

duct tape

stick it on....massage it onto the cone then rip it off...........

Audio_Rookie

iTrader: (2)

ya dustcap....dont know what I was thinking... thnx for the ideas guys....im gonna go try those ones out...keep more cooming

Bulldogger

Live with it & invert mount it. [img]tongue.gif[/img]

I'm alot of help eh.

pinhead

i found that removing the dent usually weakens the dustcap and creates driver noise
so unless replacing it i recommend leaving it alone

Audio_Rookie

iTrader: (2)

invert it lol....the install I want dosnt support that...

duct tape moved it out slightly..dont want to penetrate with pin..

Tim Baillie.

use a dab of hot glue with a stick or something

kinda like those cheap door dent removal things...

Audio_Rookie

iTrader: (2)

I was just thinking of that...some like...rock glue or something, in center with something to pull on...once its pulled out I can heat the glue and wipe it off....what you guys think?

Tim Baillie.

just use hotglue, it won't be a problem